ccna 200-301 network simulator ns2 aks u

ccna 200-301 network simulator ns2 aks u.Chewing Rods Chapter 4 Cisco Routers**? 04(4) Continue to add other devicesUse the above method to continue adding the Cisco Switch 2960, PC, and Server. The screen after adding all devices is shown in Figure 4-1-8.(5) Adding ConnectionsAfter adding the network devices, next add the cables between them, click "Cables" in Area 8 of Figure 4-1-1, and the available cables are displayed in Area 9 of Figure 4-1-1, as shown in Figure 4.1.9.Thermaltake mail and less points 5Figure 4-1-8 The screen after adding network devices 4.1.9 Cable typeThe first type of cable in Figure 4'-9 is the automatic cable (the cable type is selected automatically according to the occasion, it is not recommended to use this cable); the second type of cable is the "configuration cable", which means Console, it is the cable connecting the COM port of the computer and the Console port of the router or switch; the third type of cable is The third type of cable is the "straight-through cable", which means Copper straight-through, and the fourth type of cable is the "crossover cable". The fourth type of cable is "Crossover", which means CopperCross-over; the fifth type of cable is "Fiber", which means Fiber; the sixth type of cable is "Telephone", which means Phone; the seventh type of cable is "Coaxial", which means Coax "The eighth cable is "DCE serial", which means SerialDCE, used to connect the serial interface, a serial cable to connect two devices, one end of the cable is marked DCE, the other end is marked DTE, you need to configure the time clock at the DCE end to keep in sync. This cable starts with DCE and ends with DTE; the ninth cable is "DTE serial", similar to the eighth cable, except that the starting end is DTE and the ending end is DCEOThe PC in Figure 4-1-8 and the 2960 switch should use a straight-through twisted pair cable, which is the third cable selected. Click on the third cable with the mouse and move the mouse to the work area to see the mouse pointer change to the shape of a cable, and click on the PC with the mouse to prompt for the interface type, as shown in Figure 4^1-10.Figure 4-M0 Selecting the Interface