ccna 200 301 syllabus meaning in marathi of glass

ccna 200 301 syllabus meaning in marathi of glass.The debug message is displayed as follows.k220EIGRP*** |07In EIGRP, the loopback interface also sends and receives Hello packets. You can use passive-interface to set the loopback interface as a passive interface, which does not affect the operation of the network. The physical interface can not use the passive interface, passive interface does not send Hello group, EIGRP adjacency is not established, the route can not interact), R2 how to also receive Hello group from 23 1.2, R3sl/0 interface IP address is also assigned to 23.1.1.2, after checking, indeed R3's S1/0 interface IP address is wrong.So far, the reason is found. In fact, if you look carefully in the troubleshooting step 1, in addition to checking the interface status and protocol status, check the IP address assignment more, you may have found the cause.The first thing you need to do is to get a good idea of what you are getting into. The first thing you need to do is to get a good idea of what you are getting into.If the error step 1, 2 will be solved, and do not need to error step 3 and error step 4. Correct the IP address of the S1/0 interface of router R3, and later the following message will appear on the screen of R3.%DUAL-5-NBRCHANGE:IP-EIGRP (0) 100 :Neighbor 23.1.1.2 (Seriall/0) is up:new adjacencyHint R3 has already established an adjacency with R2. In EIGRP, the "eigrplog-neighbor-changes,, command is used by default to log the neighbor relationship changes. If you use the plus no command to turn this off, you will not see the neighbor establishment and disconnection alert messages.If duplicate IP addresses appear on the Ethernet, it is easier to detect errors. Assume that the IP address of the Fa0/0 interface of router R3 is assigned to a 13 chariot 1.1, you will see an error message similar to the following in the console of R3 and R1.