todd lammle ccna 200-301 pdf download

todd lammle ccna 200-301 pdf download.Step 5 In the ControUer Details area, define the controller management IP address, user name, and password. Step 6 In the TimeDetails area, select the UserControllerTime radio button. Step 7 If the address is resolved by DNS, enter the DNS address and domain name. You can also change the log level if you want to see more details. Step 8 Click the Start button to begin the process.This upgrade process checks all input parameters and pops up an error report if inconsistencies are found. The AP will reboot after the conversion. After rebooting, the AP will work as a light AP trying to find a controller.Note: During the upgrade process to lightweight code conversion, if the AP is an older AP without a Cisco signed certificate, it is important that a self-signed certificate is generated for the AP and sent to WLCO for all controllers associated with the AP. In this case, if CUWN has a WCS server, the self-signed certificate should be imported from the controller that the AP is currently associated with to the WCSo this can be done by refreshing the WCS controller configuration that originates from the controller that the SAP is associated with, and then extending it to all other controllers.This is important for those who are upgrading older versions of APs that support an upgrade path from autonomous APs to light code suitable for CUWN, but for those who are taking the CCNA wireless exam these are not so very important.This is available at http://tinyurl.com/4l3p3c in the article "Self-Signed CerEificate Manual Addition to the Controller for LWAPP-ConvertedAPs". Learn more about it.To convert an AP from Lightweight mode to Standalone AP, either through the Command-Line Interface (CLI, Command-Line Interfece) or by resetting the AP to the factory default values. If you use the CLI to do this, the following command is used. Use the following command. configaptftp-dcwngradatftp-server-ip-addressfilenameapnamcTo reset to the factory default settings, press the mode button until the LED turns red. This will cause the AP to reboot and ignore its light code, use 10.0.0.1 as the IP address, and send out a broadcast looking for the IOS file. That means you need a TFTP server that is on that subnet, and a default file named cplatform_name-k9w7-tardefault by convention. This is what the AP is looking for. If that file is found, the AP will downgrade. You probably won't do this unless you want to seed-a-light AP out of a light deployment and place it to be used as a standalone AP on the other side.14.3 Exam Preparation Tasks14.3.1 Review Exam Points Focus on the points marked with the "Exam Points" icon in the margin of the page that are the focus of this chapter. Table 14.2 lists these exam points.Table 14-2 Chapter 14 Exam Points ______________________________________________