todd lammle 200-301 pdf

todd lammle 200-301 pdf.The APs are listed at the bottom of the page. o Step 2 Click the AP you are using. Step 3 On the AP page, from the box labeled Support on the right side of the page, click the Download Software link. Step 4 Use the menu tree to find the AP you need, and expand the folder. Step 5 Select the link to that AP. Step 6 Enter your Cisco username and password. When authenticated, you see a page similar to the one shown in Figure 14.6. Note that this page provides the following 4 links. .AutonomoustoLightweightModeUpgradeImage oAutonomoustoLightweightModeUpgradeTooloIOS Software oIPSetupUtility(EPSU)eThe first link is the AutonomousToLightweight ModeUpgradeImage ( AutonomousToLightweight ModeUpgradeImage) o You need this image to perform the upgrade. This image is different from the one running on the controller. Remember also that the controller and AP should use the same version, but when the AP finds the controller, the mismatch between them will be corrected. If the code versions are different, the controller upgrades or downgrades the AP. The Autonomous to Light mode upgrade image only enables the LWAPP functionality on the AP. After that, the controller can handle the rest.The second link on the download page is the Autonomous To Lightweight Mode UpgradeTool o This is the software application required to perform the upgrade, which is installed on the Windows computer.214 Chapter 14 Converting Standalone APs to LWAPPFigure 14-6Cisco.com's Download AreaThe third link on the download page is IOS Software (IOSSoftware), and the fourth link is IP SetupUtilityo select the link for the software you need to download. If you wish to use IP SetupUtility to complete the configuration, click the appropriate link. After you have obtained the Autonomous to Lightweight upgrade tool software and the Autonomous to Lightweight upgrade image, you can install them on your Windows PC. Once installed, you are ready to perform the upgrade.However, the following conditions must be met before you can upgrade. The version of the flfflAP± IOS must be 12.3(7)JA or later. If this is not the case, then first select the IOS Software link on the Tap Strong Downloads page to perform the upgrade.