ccna v7 itn skills assessment

ccna v7 itn skills assessment.privileged EXEC mode and execute the command Milky Way.Authentication Target 11.0311.3 Basic Switch ConfigurationChapter 10 discussed common IOS configuration tasks for switches and routers, such as assigning host names, setting user EXEC and privileged EXEC passwords, and configuring the hardware characteristics of interfaces (speed and duplex mode).This section discusses how to assign an IP address to a switch so that it can be accessed remotely, and also does simple initial configuration of the switch using the commands described in Chapter 10 and this chapter.Practical Experience Don't forget that you don't have to manually enable the interfaces on the Catalyst switch; they are enabled by default.11.3.1 IP Addresses and Default GatewaysTo remotely manage a Layer 2 switch, you need to assign IP addressing information to it. For example, to Telnet or SSH to the switch, or to use a Web browser or SNMP workstation to remotely manage the switch, back up and restore configuration files, or upgrade the switch, you need to configure IP addressing information on the switch: the IP address of the interface and the default gateway address. Here is the configuration you will use.Switch (config) # interface vlan VLAZV_# Switch(config-vlan)# ip address IP_address subnet_mask Switch(config-vlan)# exit Switch(config)# ip default-gateway routerf s_IP_addressFor a Layer 2 switch such as the 2960, you must enter the VLAN interface to which you want to assign an IP address - this will be the management VLAN to which the PC or management device used for management belongs O Logical VLAN interfaces are often referred to as Switch Virtual Interfaces (SVI ) System Configuration Dialog assumes that the management VLANis VLAN1, but you use any VLAN-except that you must first create that VLAN (see Chapter 12). After entering the VLAN interface, use the command ip address to assign the address and subnet mask. Next, assign the default gateway: use the command ip default-gatewayo this command is essential if the switch needs to communicate with devices in other subnets over IP.