cisco ccna 1 y 2 pdf

cisco ccna 1 y 2 pdf.1. verify that interfaces fhO/O and s0 are enabled on router 2600-1. If they are not enabled, enable them.View the IP address configured for Router 2600-1± and view its routing table.Click the label Lab Instructions and select 2600-1 from the drop-down list Devices; you can also click the label NetMap and double-clickChapter 19 OSPF Routing 517device icon 2600-1o on router 2600-1 -t-, use the command show interfaces to view the configuration. If the status of interfaces faO/O and s0 is not knocked, go to those interfaces (faO/O and s0) and enable them: execute the commands configure terminal, interface type port^ no shutdownend, and show interfaces in that orderExecute the command show ip route,and you should See two directly connected networks: 192.168.1.0 connected to interface faO/O and 192.168.2.0 connected to interface s0.2. On router 2600-2_E, verify that interfaces than 0/0 and s0 are enabled. If they are not in the enabled state, enable them. View the IP address configured for Router 2600-2Ji and view its routing table. Click the tab Lab Instructions, and select 2600-2 from the drop-down list Devices; you can also click the tab NetMap, and then double-click the device icon 2600-2o On router 2600-2, verify that the status of interfaces faO/O and s0 is up, and enable them if they are not: execute the command configure in sequence terminaR interface type port^ no shutdowns end and show interfaceso Use the command show interfaces to verify that the IP addresses configured in Chapter 15 are still present. Execute the command show ip route,you should see two directly connected networks: interface fhO/O connected to 192.168.3.0 and interface s0 connected to 192.16820.3. Check the connectivity between Host-1 and Router 2600-1. Click on the tab Lab Instructions, and select Host-1 from the drop-down list Devices; also click on the tab NetMap, and then double-click on the device icon Host-1. On Host-1, ping router 2600-1: ping 192.168.1.1, which should be successful.4. Check the connectivity between Host-3 and Router 2600-2. Click on the tab Lab Instructions, and select Host-3 from the drop-down list Devices; you can also click on the tab NetMap, and then double-click on the device icon Host-3 On Host.3, ping Router 2600-2: ping 192.168.3.1, which should be successful.5. Check the connectivity between Host-3 and Router Host-1. On Host.3, ping Host 1: ping 192.168.1.10, this should fail because Router 2600-2 does not have a route to this destination device (if you look at the routing table of Router 2600-2, you will find that it does not contain 192.168.1.0/24).6. Enable OSPF on router 2600-1 using process ID 1 and add all interfaces to area 0. Click the Lab Instructions tab and select 2600-1 from the drop-down list Devices; you can also click the NetMap tab and double-click the device icon 2600-1. o On router 2600-1, execute the following commands in sequence configure terminaR router ospf 1 network 0.0.0.0 255.255.255.255 area 0 and end.