cisco 300-085 dumps

cisco 300-085 dumps.Command clear iproute clear ip route* is a privileged EXEC mode command that clears and rebuilds the IP routing table. This command should be used to clear and rebuild the routing table whenever the routing protocol configuration is modified. An asterisk (*) can be replaced with a specific network number, which removes only the specified route from the routing table. Note that the command clear only removes routes that the routing protocol learns about (dynamic routes), not static and directly connected routes. To delete static routes, you must use the command no ip route, while directly connected routes are permanent and are not removed from the routing table unless the associated interface is not functioning properly.Command showipprotocols Command show ip protocols Displays all IP routing protocols configured and running on the router, including RIP, as follows.Router# show ip protocolsRouting Protocol is "rip" Sending updates every 30 seconds, next due in 5 seconds Invalid after 180 seconds, hold down 180, flushed after 240 Outgoing Incoming update Redistributing: filter list for all interfaces is not set filter list Default version for all interfaces is not set rip control:Interface Send EthernetO 2 send version 2, receive version 2 Recv Ethernetl 2 Triggered RIP Key-chain Distance: (default 2)2 Automatic network summarization is in effect Maximum path: Routing for Networks: 192.168.1.0192.168.2.0 Routing Information Sources:Gateway-Distance Last Update 192.168.2.2120 00:00:22 192.168.3.2120 00:03:30