ccna wireless cost

ccna wireless cost..VTP has three modes: server mode (can execute, accept, and propagate changes), transparent mode (can execute changes, but ignore VTP messages), and client mode (accepts changes from the server, but does not store changes in NVRAM) o The default mode is server.. the VTP messages are only propagated through the trunk connection. For switches to accept each other's VTP messages. their domain names and optional passwords must be the same. There are three types of VTP messages: announcement requests (sent by the client or server), subnet announcements (used by the server to respond to announcement requests), and digest requests (sent by the server every 5 minutes) Configuring the revision number is used to determine whether or not you want to respond toVTP messages are processed..VTP pruning supports dynamic addition and deletion of VLANs on trunk connections, depending on whether there are active VLANs on the switch depending on the switch o It requires the switch to be in server or client mode.Configuring VLANs .. To configure VTP, specify the domain name using the command vtpdomain, specify the mode using the command vtpmode, and authenticate VTP messages using the command vtp password. To verify the VTP configuration, use the command show vtp statuso.DTP is a Cisco-specific protocol that determines whether to establish a trunk connection between two devices. There are five modes: on.desirable, auto, off, and no-negotiate; if the mode on one end is on, desirable, or auto, and the mode on the other end is on or desirable, a trunk connection is established. Mode no-negotiate enables trunking, but disables DTPo. To enable trunking on an interface on a 2960 switch, use the command use switchport mode trunk; to verify trunking, use the command show interfaces switch port| tru n k o. All ports on the switch belong to a VLAN by default lo To add a VLAN to the 2960 switch, use the command vlan; to assign an interface to a VLAN, use the commands switchport mode access and switchport access vlan; to view the VLANs and the ports assigned to them, use the command show vlano12.7 Self-Test Questions