ccna was ist das

ccna was ist das.On the 2960 switch, VTP configuration is done in global configuration mode.switch(config)# vtp domain VTP_domain_nameswitch(config)# vtp modeserver|client|transparentswitch(config)# vtp password VTP_passwordswitch (config)# vtp pruningCommand vtpdomain Assigns a domain name to the switch. Do not forget that for a switch to share VTP information, it must be located in the same domain and messages from other domains are ignored. If no domain name is configured, the switch will be informed from the server's announcements.Table 12.3 Default VTP Configuration ValuesAll other configuration commands are optional. The second vtp command specifies the VTP mode of the switch; if this command is not configured, the mode defaults to server. the switch can be configured with a VTPMD5 password that must be the same on all switches in the same domain. The switch will use this password to verify VTP messages from other switches, and if the hash in the VTP message is incorrect (this hash signature is generated from the VTP message using the password and the MD5 algorithm), the switch will ignore the VTP message. On the 2960 switch, trimming is disabled by default, but you can use the command vtppruning to enable or disable it. It is important to note that if pruning is enabled on the server switch, it will propagate this setting to all other server and client switches in the domain.After you have configured VTP, use the following command to check the configuration.switch# showvtp status VTP Version : 1 Configuration Revision : 17Maximum VLANs supported locally : 255Number of existing VLANs : 7VTP Operating Mode : Server