ccna v6 practice final exam

ccna v6 practice final exam.Table 11.4 Status Modes and Port LEDsIf you press the MODE button once, the STAT LED will go out and the DUPLXLED will come on. At this point, the LED above each port refers to the port's duplex setting: an off LED means the port is set to half duplex, a green LED means the port is set to full duplex. If the MODE button is pressed again, the DUPLXLED will go out and the SPEEDLED will come on. The 2960 switch supports 10/100 and 10/100/1000 ports, while the 2960X and 2960XR switches also support 10 Gbit/s cascaded ports.When the SPEEDLED is on, the LED above the port indicates the port's operating speed: an LED that is off indicates that the port is operating at 10 Mbit/s; green indicates a speed of 100 Mbit/s; and blinking green indicates a speed of 1 Gbit/s.If the switch port LEDs are all off, confirm that you powered up the switch, reinsert the cable connectors into the ports, and confirm that you are using the correct cable type: straight-through and crossover cables.If you press the MODE button again, the STAT LED will light up again. As you can see, use the MODE button to switch between modes. When the current mode is DUPLX or SPEED, it will automatically switch to STAT mode after 1 minute.Authentication Target 11.02112 Switch StartupOnce you have a basic understanding of the 2960 switch chassis, you can begin to learn about the switch boot process: this includes performing hardware checks, loading the IOS, and finding and applying configuration files. These steps are discussed in the next few subsections.11.2.1 The Switch Boot ProcessWhen first accessing the switch, be sure to plug one end of the reversing cable into the console port of the switch and the other end into the COM port of the computer