ccna 200-301 official cert guide, volume 1

ccna 200-301 official cert guide, volume 1.Privilege levels can also be assigned to users in local data. to assign a specified username to level 5, enter the following command.username SUPPORT privilege 5 secret cisco5A user logged in with the username SUPPORT can access only privilege level 5, and of course level U2.2.1.4 Assigning Privilege LevelsThe JR-ADMIN account is able to use all level 1.5 commands and the reload command. The account must be assigned a higher level, such as level 10. Level 10 automatically inherits all commands at lower levels. Use the following commands to assign reload privileges to level 10 and JR-ADMIN accounts EXEC mode command: privilegeexeclevel10reload enable secretlevel10cisco10 username jr-adminprivilege10secret cisco10 By executing these commands, only users at level 10 and higher can use the reload command. The user with the username JR.ADMIN is given level 10 and related commands. including all lower-level commands. To enter level 10 mode, use the enable 10 command and the password cisco10oThe ADMIN account defaults to level 15, with available access privileges EXEC mode. In this example, no custom commands need to be defined. The user password can be set with the enable secret level 15 ciscol23 command. However, it does not override the enable secret password, which can also be used to access level 15. Use the username ADMIN privilege 15 secret ciscol5 command to set the ADMIN user with the password ciscol5 for level 15.The privilege and secret keywords are not interchangeable when assigning a username to a privilege level. For example, instead of assigning the USER account to level 1, the usernameUSERsecretcisco privilege 1 command creates an account with a password of cisco privilege 1.To access privilege level 15, you must use the enable 15 command and the cisco 15 password.To access an established privilege level, enter the enable level command in user mode and enter the password for the appropriate level. You can change from a lower level to a higher level using the same command.From level 1 to level 5, enter enable 5 at the EXEC prompt.