ccna 200-301 dumps full questions

ccna 200-301 dumps full questions.Therefore, the contents are less likely to be lost.Forward ) The sending of frames through an interconnected network device to their final destination.Forward Delay An STP timer with a default delay of 15 seconds that specifies the length of time an interface will remain in the listening and learning states.Also known as a Forwarding Delay timer.Forwarding State An interface operation that is not restricted by STP.Forwarding state is a STP and RSTP port state that is not restricted by STP. ForwardRoute From the perspective of one host, the route through which packets are transferred from that host to other hosts.FrameRelay An internationalized standard data link protocol that defines the ability to create a frame switching (or packet switching) service that allows a DTE device (usually a router) to send data to other devices using a physical link to the Frame Relay service.Frame Relay DCE (FrameRelay DCE) Frame Relay switch. Frame Relay DTE ( Frame Relay DTE ) A client device, usually a router, connected to a Frame Relay access link.FrameRelayMapping Information about the correlation or mapping between the DLCI of Frame Relay and the Layer 3 address of the DTE, which is identified by the local DLCI of the device on the other end of the VC.Framing Layer 2 follows the OSI specification of Layer 1 for how to send bits. For example, when an electrical signal is received and converted to binary, group framing identifies the information fields within the data. FullDuplex In general, any communication between two devices that are communicating can send and receive data at the same time. For Ethernet LANs, this is the ability of two devices to send and receive data at the same time. This allows only two workstations in a conflicting domain. This can be achieved by turning off the