ccna 200 301 official cert guide volume 1 free download

ccna 200 301 official cert guide volume 1 free download.(3) A company uses a dual stack deployment model for IPv4 and IPv6, using EIGRP as the routing protocol for both. Router R1 has IPv4 and IPv6 addresses only on interfaces G0/0 and S0/0/0, both of which support EIGRPv4 and EIGRPv6,and the router ID is explicitly set for both protocols. Comparing the EIGRPV4 and EIGRPV6 configurations, which of the following statements is correct?372 Chapter 10 Implementing IPv4 EIGRPa. The EIGRPv6 configuration uses the router eigrpasn global commandb. Both protocols use the router-id router-id router subcommandc. Both protocols use the networknetwork-number router subcommand d. EIGRPv6 configuration uses the ipv6eigrpasn interface subcommand (4) There are three redundant IPv6 routes on Rl for connection to IPv6 subnet 9 (2009:9:9:9::/64), which is connected to router R9's G0/0 interface. Rl's current successor route uses R2 as the next-hop router. feasible successor routes go through routers R3 and R4. then another engineer makes a configuration change in the network that results in no lines on R1 that can connect to subnet 9. Which of the following configurations would cause Rl to have no connection topath to subnet 9? a.Leave R9's G0/0 interface in a passive stateb.Change R2's EIGRPASN to another value while maintaining the same configuration c.Change the Hello timer on all of Rl's interfaces from 5 to 4d.Change the EIGRPASN of Rl to another value while keeping the same configuration(5) Rl and R2 are two routers that are connected to the same VLAN. Which of the following answers will prevent these two routers from becoming EIGRPv6 neighbors? (Please select two answers.)a.Mismatched Hello timers b.Mismatched ASNs