ccna 200 301 lab manual

ccna 200 301 lab manual.Messages are sent to reserved multicast addresses (FF02::5 for all OSPF routers ,FF02::6 for all DR and BDR routers), similar to OSPFv2 using 224.0.0.5 and 224.0.0.6. so what is the difference between the two? The following list mentions some of the differences. Note, however, that most of these differences are outside the scope of thisHowever, note that most of these differences are beyond the scope of this book. The following is a list of the differences between the tasting volumes. Type 3LSA Name. OSPFv3 neighbors are on the same IPv6 subnet and do not need to have IPv6 addresses while OSPFv2 neighbors must be on the same IPv4 subnet.OSPFv3 uses the new LSA type while OSPFv2 does not (this point is also out of the scope of this book).14.2 Basic Content 358LSA types 1, 2, and 3 are defined internally in different detail (details of which are outside the scope of this book). As you can see, the list of differences is very short. Because of the numerous similarities between OSPFv3 and OSPFv2, Cisco has kept the configuration commands similar as well. Figure 17-5 summarizes the OSPFv3authentication command and the kinds of information it displays. Note that all the commands that list ipv6 change ipv6 to ip,create the OSPFv2 counterpart, the.......... .Config 4----------showrunning-configipv6ospf pid area areajdCommand. show ipv6 protocols 'startup V---------------------------------show ipv6 ospf interface /............ Interface use Hello show ipv6 ospf interface type numbershow ipv6 ospf interface brief discover ospf neighbor; show ipv6 ospf neighbor type number:neighbor** -----------------------------------show ipv6 Flood LSAs