ccna 200 301 fees

ccna 200 301 fees.Multi-region. Examples of SPFv3 ConfigurationsMany of the OSPFv3 examples listed in this chapter work in the same way as OSPFv2. Therefore, to show as many of these similarities as possible, the configuration section will use an example multi-area configuration with the exact same interconnect network topology as the multi-area configuration example in the 0SPFv2 chapter (Chapter 8, "IPv4OSPF").Before discussing the configuration, Figure 17-1 begins with a description of the design, showing the IPv6 subnet. The diagram does not show the IPv6 addresses of individual routers, thereby reducing clustering, but to make the addresses easier to identify, the addresses all end with the same number as the router number. For example, the five interface addresses of router R1 all end in 1.2001:DB8:1:23/64Figure 17-1 Interconnection Network for Multi-Region OSPFv3 Configuration ExampleNext, Figure 17-2 shows the OSPFv3 region design. Those with good memories will notice that this design is almost identical to Figure 8-12 in Chapter 8, which defines the zone design in the multizone design example in Chapter 8. This design has the R2 and R3 internal routers within area 23, the R4 internal router within area 4, and the R1 area boundary router (ABR) connected to all three areas.Region 4' 'Figure 17-2 Region Design for Multi-Region OSPFV3 Example352 Chapter 17 Implementing IPv6 OSPF "Do I Know This Already?" Answers to the subtests.(1) b(2) b(3) b(4) a, d, and e (5) b and d(6) c single-area configuration for three internal routersIn this example, the configuration on the three routers reviews the single-area OSPF configuration at the ICND1 level. In a multi-region OSPF design, the configuration on any internal router-a router with all interfaces connected to a single region-is the same as the single-region configuration because all interfaces are placed in the same region.