ccna 200 301 booksmart reviews

ccna 200 301 booksmart reviews.Figure 3.8 Ethernet cable: reversing the wireThis is probably the easiest type of cable to make; you just cut the crystal tip off one end of the straight-through cable, reverse the wire sequence and press on a new crystal tip, and you're done.Figure 3.9 Port parameter settings for reversed wire connections3.2 Ethernet CableOnce you have connected the PC to the Cisco router or switch using the correct cable, you can open HyperTerminal to create a management connection so that you can configure this device. Usually we use a terminal emulator such as SecureCRT or Putty. the debugging process is shown below.1. Open HyperTerminal and enter a name for the connection. I don't care what you name it, but I always name it Cisco, and then click OK.2. Select the communication port - COM1 or COM2, whichever the PC± is open.3. Now set the port parameters. Using the default values (2400 bit/s and no flow control hardware) will not work, you must set the port parameters according to Figure 3.9.Note that the bit rate in the figure is set to 9 600 and the Flow control is set to None. At this point you can click OK, then press Enter, and you are ready to connect to the Console port of the Cisco device. The different RJ45UTP cables have already been described in the previous section. Think about which cable should be used to connect between the switches in Figure 3.10.AB