ccna 200 301 booksmart rotten tomatoes

ccna 200 301 booksmart rotten tomatoes.3.2 Ethernet CablesEthernet cables are an important topic, especially for Cisco certification exam candidates.You need to have a good understanding of the following 3 types of cables. Chisel straight-through cablecrossover cable . Reverse Wires The following describes these three types of cables in order.3.2.1 Straight-through cableStraight-through hair is used to connect the following devices. Otter hosts to switches or hubs.The hub/switch host straight-through cable uses 4 wires to connect Ethernet devices. 11 This type of cable is relatively simple and Figure 3.6 gives the 2 ---------------------------------------------. used by the straight-through line. 2 the 4 wires used. 33 Note that the straight-through cable uses only pins 1, 2, 3, and 6 66; simply connect 1 pair of 1, 2 pairs of 2, 3 pairs of 3, and 6 pairs of 6Figure 3.6 Ethernet cable: the straight-through cable is connected and the two devices are immediately connected. But remember that it is only an Ethernet cable and cannot support voice or other LAN or WAN technologies. The connection between the construction router and the switch or hub.Figure 3.6 applies in a 10/100Mbit/s Ethernet environment. gigabit Ethernet will use 4 pairs of wires.3.2.2 Crossover cablesCross-cry cables are used to connect the following devices. Switch to switch connections. . Hub-to-hub connections. Host to host connections. Hub-to-switch connections. Direct connections between routers and hosts. The crossover cable also uses the same 4-wire used for the straight-through cable, except that here we have connected different pins together.