ccna 200 301 syllabus meaning hindi to english online

ccna 200 301 syllabus meaning hindi to english online.4. solution: question B asks: why does RouterA show multiple unequal spends to the 192.168.81.0/24 network? This question can refer to Section 7.2.1 of this chapter. the figure shows the topology table. the topology table of EIGRP can show all paths to the destination. After experimental testing, we found that the ''showipeigrptopology w command only lists all the paths that can satisfy the feasibility condition, that is, the successor paths and the feasible successor paths, and the Wshowip eigrptopology all-links,, command onlycan display all the paths. The reader can use these two commands to verify the statement here after the EIGRP troubleshooting in Section 7.2.1 of this chapter is completed, or there may be a problem with the router IOS version, but only B is the most appropriate answer for this question.5. Solution: DThe question asks: which routing protocol uses bandwidth and delay as metrics by default? The only routing protocols that use a composite metric are IGRP and EIGPR, which both use bandwidth and delay as metrics by default.6.Solution.A Question Q: Why does the network in the figure fail to converge? Note that the router in the figure has 192.168.20.64/26 subnets on router New York and 192.168.20.128/26 subnets on router Sydney, which both belong to the primary class network 192.168.20.0/24,If auto-summarization is not turned off, an auto-summarized EIGRP route is generated on both routers "D 192.168.20.0/24 is a summary, 00:14:35, Null.", and both routers will also notify each other of the 192.168.20.0/24 route, because the routers themselves already have 192.168.20.0/24 routes to the NullO port, and neither is learn the route to theparty's routes, the result is that neither can learn the other /26's subnet routes and network convergence fails. In summary, the rtnoauto-summary w command should be applied to the router.Question B Q: The Branch router shows a route for 172.16.0.0/16, while the actual network on the HQ router is 172.16.1.0/24,why does the routing table appear on the Branch router as 172.16.0.0/16?First note that this is a route marked "D "The 172.16.1.0/24 subnet on the HQ router is automatically summarized as the classful 172.16.0.0/16, which is a result of not turning off EIGRP auto-summary. Because EIGRP auto-summarization is not turned off on the HQ router, some candidates may mistakenly think that it is caused by not turning off auto-summarization on the Branch router, but actually it is not. If the route sent by the HQ router is a 172.16.1.0/24 subnet route, and the Branch router does not turn off auto-summarization, the Branch router will not summarize the 172.16.1.0/24 subnet routes it learns from.Ground-generated routes are valid and invalid for learned routes. The reader can verify this conclusion by turning off auto-summary for HQ routers and turning on auto-summary for Branch routers.- _________________________ ____________________________________________________