200 301 practice test

200 301 practice test.Now, find the debug message that indicates that G0/2 transitions to the learning state, and then find the one that eventually indicates that it changes to the forwarding state. What is the time interval between these messages? The timestamps of the two messages show a 15-second time difference. In this experiment, the switch is using the default MaxAge setting value (15 seconds). Therefore, these debug messages are able to determine the steps that STP needs to perform when transitioning an interface from a blocking state to a forwarding state.If debugging was not enabled when the overhead was configured. you can also subsequently use the show command to confirm that SW3 made the same choice of using port G0/2 as the RP. example 2-4 shows the new STP port overhead on SW3 with the show spanning-tree vlan10 command. along with the new root port and root overhead. Note that G0/2 is now the root port. The top of the output lists SW3 root overhead as 8, which is consistent with the analysis shown in Figure 2-5.Example 2>4 New STP state and settings on SW3SW3# show spanning-tree vlan 10SpanningIMMWPort 26 (GigabitEthernet0/2)Hello Time 2 secMax Age 20 sec Forward Delay 15 secBridge ID Priority 32778 (priority 32768 sys-id-ext 10) Address f47f.35cb.d780 HelloTime 2secMaxAge20sec ForwardDelay15sec Aging Time 300 sectree enabled protocol ieee VLAN0010