ccna 200 301 syllabus of errors definitions

ccna 200 301 syllabus of errors definitions.k216. Shouting Chapter 7 EIGRP*** I07alternative paths can be found immediately. An FS is also a neighbor that has a loop-free path to the same destination network and satisfies the feasibility condition..FC (FeasibilityCondition,FeasibilityCondition): for a neighbor router to be an FS,it must be able to satisfy FC (FeasibilityCondition) o FC (FeasibilityCondition) is that RD (Reporting Distance) must be less than FD (Feasible Distance), that is, the minimum distance from the neighbor router to the same destination network must be smaller than the minimum distance from this router to the same destination network, so that neighbor router to satisfy the FC condition.The topology table for R1 shows the following: p 2.0.0.0/8, 1successors, FDis 133120 via 21.1.1.2 (133120/128256),FastEthernetO/O via 12.1.1.2 (2297856/128256),Seriall/1FD to 2.0.0.0/8 is 133120,R2 RD via serial port is 128256,satisfying FC,i.e. RDvFD.Router R2 is Successor and FS for R1 to 2.0.0.0/8.When the Ethernet link between R1 and R2 is broken, DUAL does not need to be recalculated and R1's route to 2.0.0.0/8 immediately switches over to the serial link. In fact, all non-FD paths that can appear in the topology table displayed by "show ip eigrp topology" satisfy FC and are FS. satisfy FC,cannot be FS. 2.2. EIGRP troubleshooting In the topology shown in Figure 7-2-1, configure EIGRP to complete the interconnection of the network. Write the text file shown in Figure 7.2_2, and then paste the corresponding configuration into the console of Rl, R2 and R3 to complete the configuration. The reader can directly open the "Configure \7\eigrp debugging .txt" file in the CD to paste, experienced engineers can greatly save the configuration time by this configuration method. Beginners may feel uncomfortable because there is no online help, and may even enter the wrong command, more practice, you can overcome. Especially for beginners, be sure to watch the console prompt when pasting to see if there isThere is an error command prompt. Paste the configuration corresponding to R1 in Figure 7-2-2 in the console of router R1, and the display will be as shown in Figure 7-2-3, and you can see that all commands are positivelyExecute it correctly and no error message appears. Similarly paste the configuration of R2 and R3.217 J