ccna 200 301 syllabus plural spelling of potato

ccna 200 301 syllabus plural spelling of potato.Question F asks: which set of commands must be configured in order to establish a Telnet session to the router? This question can be referred to section 4.3.5 of this chapter, Telnet is an application layer application, it uses VTY line, by default, the line to be accessed has a password, the command to set the password under the VTY line is password string, and the other command login under the VTY line is the default, can be written or not. If you want to set the password in theYou can access this line without setting a password on the VTY line during Telnet. you can enter the command nologin under this VTY line, i.e., no authentication is required.8. solution.The BE question asks: which two passwords must be configured in order to be able to connect to a secure Cisco switch using Telnet and to configure the switch? This question can refer to section 4.3.5 of this chapter to configure the VTY line password to allow remote login and the privileged password to allow remote login, which allows access to the specialprivilege mode, and thus the configuration of the switch. The configuration of the switch is covered in a subsequent section, but the configuration commands for Cisco router and switch remote login are the same.9.Solution.C QUESTION Q: The diagram shows remote login to the ACCESS1 router from the Remote27 router. what command can be used to solve this problem? Telnet by default requires a password to be set for the VTY line because there is a login setting by default under the VTY line, which indicates that authentication is turned on.Therefore, if a password is not set under the VTP line, access is not allowed using the VTY line. So you need to set a password under the VTY line of the device being accessed (in this case ACCESS 1), using the command password will work. so the correct answer is C.10. Solution: Question E asks: What does the MTU 1500 bytes in the figure mean? MTU is the abbreviation of Maximum Transmission Unit.The MTU shown here is the MTU at layer 3. o The protocol data unit is called a packet at layer 3. o It is called a segment at the transport layer, and is added to the packet header at the network layer. At the data link layer, it is called a frame, which encapsulates the packet and is larger than the packet.