ccna 200 301 syllabus uaeh gestion empresarial

ccna 200 301 syllabus uaeh gestion empresarial.3. Adding routesUse the following commands to add routes to RK R2 and R3. This chapter does not explain the commands for adding routes, only the network connectivity is completed here, and the static route configuration commands will be explained in the next chapter. R1 is configured as follows: R1(config)#ip route 0.0.0.00.0.0,0 12.1.1.2R2 is configured as follows.R2(config)#ip route 192.168.1.0255.255.255.255.0 12.1.1.1, R2(config)#ip route 3.3.3.0255.255.255.255.0 23.1.1.3R3 is configured as follows: R3(config)#ip route 0.0.0.00.0.0.0 23.1.1.24. To further test the connectivity of the networkOn router R1, ping router R3 at 3.333, the result is as follows: Rl#ping 3.3.3.3Type escape sequence to abort. ,Sending 5,100/-byte workers CMP Echos to 3.3.3.3, timeout is 2 seconds: t!iII Successrate is 100 percent(5/5), round-trip min/ avg/max == 8/36/64 ms Rl# router sends 5 ping packets by default and displays "!" when it receives an answer o Use the following command on router R3 to turn off loopback 0: R3(config)=#intlo0R3(config-^if)#shut on router R1 ping router R3 again on 3.333,the result is "... ...", indicating a timeout. The reason for the timeout is that a routing loop has been created here, which will be discussed in depth in the next chapter of this book in the section "5.4 Default Routing". Turn on router R3's loopback0, turn off router R2's S1/1 interface, and ping router R3's 3.3.3.3 on router R1 again, the result is as follows.Rltping 3 33.3The result is as follows: Rltping 3 33.3: The first time that the company is in a position to do this is when the company is in a position to do this.