ccna 200-301 blueprint download jay-z

ccna 200-301 blueprint download jay-z.There are LAN interfaces and WAN interfaces on the router, and different interfaces of the router must be configured in different subnets. The command to configure the IP address of a router interface is as follows.Router (config)#int sl/1 configures the router's WAN interface S31/1 a Rcmter fcr. ; this portis link to internet Port Description Information @ Router(config-if} #ip address 12.1.1.1 255.255. 255.0 Configuring the Work P Address and Subnet Mask ° Router(config-if)#noshutdown The router's interfaces are all off by default, and you need to use the K ShMdOW command to open the interfaces. Returning to global configuration mode Router(config-if)#exit without returning to global configuration mode can actually be done under an interface. Go directly to another interface. under.Router(config)tintfa 0/0 configures the router's LAN interface fatstEihemet 0/0o Router(config-if)#ip add 13.1.1.1 255.255.255.0 Configures the TP address and subnet mask. Router(config-if)#noshut opens the interface .For WAN interfaces there will also be clocking and encapsulation protocols involved. The WAN interface needs to be configured with a clock to provide synchronization, and in the experimental environment, the clock is configured on the cable DCE side using clockrate with the following command: Router(config)tintsl/1 Router(config-if)#clock rate 64000The encapsulation protocol for the WAN is discussed in the WAN section.Mouth Note: All routers on the CCNA simulator rack do not need to be configured with a clock, but in a real-world environment or on some low-end routers, the clock is sometimes a parameter that must be configured. Be sure not to forget this especially on the CCNA exam.Secondary addressMultiple IP addresses can be configured on an interface of a router, and just like most Windows operating systems, multiple IP addresses can be added to a single NIC, and multiple IP addresses can belong to the same IP subnet or to different IP subnets. The command used is as follows.Router(config) tintfa 0/0 Configures the router's LAN interface f&stethwmet 0/0^104 J