ccna 200-301 complete video course and practice test livelessons

ccna 200-301 complete video course and practice test livelessons.The contents of the configuration file are saved in text form so that its contents can be displayed on the router console terminal or on a remote terminal. This is important because when a configuration file is created and modified on a computer connected to the network and then loaded into the router using the TFTP protocol, the contents of the file are not recognized by the router because the text editor or word processor used usually adds some control characters to the saved file. Therefore, when creating and maintaining a configuration file using a file editor or word processor, remember to save the file as an ASCII text file (.txt) o Once the configuration file is saved, it can be stored in NVRAM and loaded into the high end address space of memory each time the router is initialized.5. Outgoing information at router startupIn PacketTracer, open the First.pkt file created in Section 4.1.1, click on either of the two routers, and select the "Command Line" tab to see how the router boots up. The reader can also power off the router and then power on the router again to allow the router to reboot and watch the router boot up. Router91 AThe output messages generated at startup are as follows (italicized sections are comments) :Note: All shaded sections in this book indicate router output or configuration commands, and unless otherwise noted, all shaded sections in italics indicate comments added by the author. If it is just the output of the router without comments, it will be shown without shading.System Bootstrap, Version 12.3(8r)T8, RELEASE SOFTWARE (fcl) Cisco 1841 (revision 5.0) with114688K/16384K bytesof memory.Self decompressing theimage : The TOS file is copied to Rm, as the worker OS file used is compressed, and decompression is performed here.Bootstrap, Version 12.3(8r)T8, RELEASE SOFTWARE (fcl) Cisco 1841 (revision 5.0) with114688K/16384K bytesof memory.Self decompressing theimage : ######################################################################### [OK] omitted section Cisco IOS Software, 1841 Software (C1841-IPBASE-M), Version12.3 (14)T7, RELEASE SOFTWARE (fc2j. This shows the version information of the IOS file.