ccna 200-301 pdfdrive

ccna 200-301 pdfdrive.Appendix B Glossary 373service area. The evaluation equation is as follows: EIRP = transmitter output power - cable loss + antenna gain. Vertical plane (elevation planeE-plane) A vertical pattern in which the signal does not propagate uniformly. Enhanced Data RateEDR (Enhanced Data Rate) A Bluetooth 2.0 feature that provides up to 3 times the bandwidth to Bluetooth clients. Exposed nodeissue When two wireless cells are on the same channel and they are not in contact with each other.LightweightExtensibleAuthentication Protocol (LEAP) uses a proprietary algorithm to create the initial session key. Line-of-Sight LOS (Line-of-Sight) Propagates signals between two points that appear to be a straight line distance apart. The link budget is a value that describes all gains and losses between the transmitter and receiver, including attenuation, antenna gain, and various other possible losses.The link budget is the value of all gain and loss between the transmitter and receiver, including attenuation, antenna gain, and various other losses that may occur. local mode The standard mode of an AP. LWAPPdiscovery request An LWAPP message used to discover the controller. EWAPP discoveryresponse The controller's response to an LWAPP discovery request message sent by the AP.request message from the AP.managementframe A management frame used to join and leave a wireless cell. Management frame protection MFP (ManagementFrameProtection) A method for detecting spoofed management frames, where a valid frame contains a hash value that the spoofed frame should not have. master controller A controller configured in the GUI interface via CONTROLLER >Advanced > MasterControllerMode The controller configured. MaximumTransmissionUnit (MTU) The maximum frame length supported by an interface. Message Integrity Check MIC (MessageIntegrityCheck) The cryptographic hash included in each management framealgorithm to ensure that data is not tampered with. MicrosoftChallengeHandshake AuthenticationProtocol version 2 (MS-CHAPv2) amobilitygroup A setting that defines a controller as a member of a group. monitoring mode (immitor mode) An operating mode in which the AP scans all channels without interruption to perform an illegal control. When operating inWhen operating in this mode, the AP cannot provide services to clients. multipath The definition of a partial signal that is reflected and reaches the receiver out of order. Multiple Basic Service Set Identifier MBSSID (Multiple Basic Service Set Identifier) Used when the AP is in more than one