when will ccna 200-125 expire

when will ccna 200-125 expire.12.2 Basic Topics 304Note: When adding buildings to the campus map, consider that their horizontal and vertical spans should be greater than or equal to the size of the floor dimensions that may be added later. This may be a problem when you build a map of the basement of a building and then build a map of the first floor. If the first floor is larger than the basement, you can't create a first floor. In fact, you cannot create any floor that is larger than the basement area. WCS does not allow larger map levels to be added later. More information can be found in Addingand Using Maps in the website http://tinyurl.com/6f8apm CiscoWirelessControlSystemConfigurationGuide,Relese4.1.When adding a building, the following information needs to be entered. Building name. Contact. Number of floors. Number of basements.Horizontal and vertical level dimensions (in feet). A two-story building is shown in Figure 18.12.Figure 18-12 Two-Story BuildingA new floorarea can be added from the drop-down list.0 The floorarea provides you with an overview of the entire environment, allowing you to add useful information such as floor type, height, and mirror files. This configuration page is shown in Figure 18.13. Floor types include Cubes, WalledOffices. drywallOfficeOnly, and OutdoorOpenSpaceo305 Chapter 18 Enterprise Wireless Management with WCS and Location DevicesThis is important because it helps WCS with RF modeling.Figure 18-13 Hotspot Map in WCSOnce you have created the floor area, you can add APs. You can see that the elements described earlier are hierarchical (e.g. Campus > Building > FloorArea > AP). This is actually a logical approach. Now when you add APs, you should be careful about accuracy. Be sure you are adding the correct AP type, antenna configuration, and location, etc. RF Prediction occurs when you place each AP on a floor area.RF Prediction generates a map of hotspots, including APs, clients, and illegal clients.