the new ccna 2020

the new ccna 2020.13.3.2 Explain key termsExplain the key terms in this chapter and check your answers against the glossary. port,interface,WLAN,staticinterfacedynamicinterface,roaming,mobilitygroupoConnecting to a Standalone AP: A brief discussion of how to access a standalone APO using various methodsBasic configuration using Express Setup and Express Security: How to use Express Setup and Express Security configuration to set up a standalone APO for wireless accessConverting to LWAPP: How to Convert a Standalone AP to Lightweight Mode Using the Upgrade Tool.Chapter 2 Converting a Standalone AP to LWAPPMany Cisco APs can operate in autonomous mode or in light mode. However, APs that operate in both modes are usually in standalone mode. Some may choose to have these APs operate in standalone mode, while others may simply convert them to Lightweight Access Point Protocol (LWAPP) mode - enhancing the performance of these APs to integrate them into the Cisco Unified Wireless Network (CUWN, CiscoUnifiedWirelessNetwork) into the newer networks. In this chapter, you will learn how to access standalone APs, how to configure them in standalone mode, and how to convert them to light mode.The first thing you should do is take the "Do I Know This Already?" test question. If you get 80% or more correct, you can go straight toIf you get less than 80% correct, you should spend time studying the entire chapter. Refer to Appendix A, 'Do I Know Already? TestAnswers to Questions" to check your answers.14.1 "Do I Know Already?" Test Questions