cisco ccna kepzes

cisco ccna kepzes.5. In router2600-2 Ji Enable Frame Relay: Enable interface seriall; set Frame Relay Frame Type to Cisco; set LMI Type to ITU; assign IP address. Click the tab Lab Instructions and select 2600-2 from the drop-down list Devices; you can also click the tab NetMap, and then double-clickHit the device icon 2600-2 o Enable the Frame Relay interface: configure terminal interface seriall and no shutdown o Set the encapsulation type and frame type: encapsulation frame-relay o Set the LMI type: frame-relay Imi-type q933a. assign an IP address to the interface: ip address 192.168.10.2 255.255.255.0. exit configuration mode: endo6. check the operational status of the interface and the LMI. Use the command show interfaces to verify that the status of the interface is up and up, and that the LMI is operating normally. Use the command show frame-relay Imi to confirm that the router is sending and receiving LMI information.7. On router 2600.2, check the PVC configuration and status. To view the resolution entry: show frame-relay mapo To view the PVC: show frame-relay pvc,the status of this PVC should be ACTIVEoChapter 25 Frame Relay 7018. On Router 2600-1Ji, check the PVC configuration and status. Click the tab LabInstructions and select 2600-1 from the drop-down list Devices; you can also click the tab NetMap, and then double-click the device icon 2600.1. to view the resolution entry: show frame-relay map. to view the PVC: show frame-relay pvc, the status of the PVC should be ACTIVEo9. ping the address of the Frame Relay interface on router 2600-2. Check connectivity: ping 192.168.10.2, which should be successful.10. on router 2600-1, configure a static route to the network connected to router 2600-2. View the routing table. On router 2600-1, configure a static route to 192.168.3.0/24: configure terminal and ip route 192.168.3.0 255.255.255.0 192.168.10.2o Exit configuration mode: end. view the routing table and look for the previously configured static route: show ip route0 show ip route011. on router 2600.2, configure a static route to the network connected to router 2600.1. View the routing table. Click the tab Lab Instructions and select 2600-2 from the drop-down list Devices; you can also click the tab NetMap and double-click the device icon 2600-2. On router 2600.2, configure a static route to 192.168.1.0/24: configure terminal and ip route 192.168.1.0 255.255.255.0 192.168.10.1 Exit configuration mode: endo view routing