cisco ccna jobs australia

cisco ccna jobs australia.The command frame-relay map defines the manual parsing process. The parameter protocol name specifies the Layer 3 protocol to be resolved, such as IP, IPX, or AppleTalko if two protocols, such as IP and IPX, are running between the current DTE and the remote DTE, a frame-relay map command will need to be configured for each protocol and each map. The protocol name is followed by the remote DTE's Layer 3 address (destination_address), such as its IP address. The Layer 3 address is followed by the local DLCI number that the router should use when traveling to the remote DTE. These three parameters are essential.There are also two optional parameters: the parameter broadcast and the frame type parameter. By default, local broadcasts and multicasts are not propagated through manually resolved PVCs; therefore, if you are using a routing protocol such as Routing Information Protocol (RIPv2), Open Shortest Path First (OSPF), or Enhanced Interior Gateway Routing Protocol (EIGRP), the routing updates they generate will not be propagated through the PVC unless the parameter broadcasto do not configure this parameter if you do not want broadcast traffic to be carried through the VC. In this case, static routes need to be configured on both Frame Relay DTE±s.The beginning of this section describes how to modify the encapsulation type of Frame Relay frames using the command encapsulation frame-relay, which enables you to specify one of two frame types: ietf or cisco, where cisco is the default setting. The problem with this command is that it sets the same encapsulation type for all VCs on the specified interface. When configuring manual resolution, you can specify the encapsulation type for each VC separately; if you do not do so, the encapsulation type of the VC defaults to the encapsulation type of the serial interface.To configure manual resolution to specify the local DLCI that should be used for travel to a remote DTE, use the command frame-relay map. by default, broadcasts are not propagated through manually resolved VCs unless you specify the parameter broadcast-which allows routing protocols such as RIP, EIGRP, and This allows routing protocols such as RIP, EIGRP, and OSPF to run on manually resolved VCs.To demonstrate how to configure PVC manual resolution, look at an example, as shown in Figure 25.9. Router A is configured as follows.RouterA(config)# interface serial 0 RouterA(config-if)# encapsulation frame-relay ietf RouterA(config-if)# frame-relay Imi-type q933a RouterA( config-if)# ip address 192.168.2.1 255.255.255.0 RouterA(config-if)# frame-relay map ip 192.168.2.2 103 broadcastLMI192.168.2.1 DLCI103 frame relay ansiLMI Frame Relay 192.168.2.2 q933a switch DLCI301Figure 25.9 PVC Manual Resolution Example