cisco ccna continuing education

cisco ccna continuing education.. RIPng builds on RIPv2 and uses the multicast address FF02::9, which represents all RIP routers, and sends routing information via UDPsends routing information to port 521O . In a dual stack, the device runs both IPv4 and IPv6 stacks. . 6to4 tunneling technology transmits IPv6 packets as an IPv4 payload and can connect different IPv6 networks over an IPv4 networknetwork over an IPv4 network.. The command ipv6 unicast-routing globally enables IPv6 and is the first IPv6 command that must be executed on the router. The command ipv6 address specifies the prefix and prefix length and uses EUI-64 to generate the interface ID.. The command ipv6 router rip tag enables the RIPng routing process on the router. The command ipv6 rip tag enable associates an interface to a specific RIPng routing process. The command show ipv6 rip displays the configuration of the RIPng routing process. The command show ipv6 route rip displays the RIPng routes in the IPv6 routing table.. The command ipv6 router ospf process_ID enters the OSPFv3 routing process, while the commands router-id and area specify the router ID and the area to which the router is connected, respectively. The command ipv6 ospf processJD area area_number associates the interface to a specific OSPF routing process and area.. The command ipv6 router eigrp autonomous enters the EIGRPforIPv6 routing process and the command no shutdown enables the EIGRPforIPv6 routing process (in some IOS versions. you must execute this command). The command ipv6 eigrp autonomous system associates the interface to a specific EIGRPforIPv6 autonomous system.Chapter 23 IPv6 63523.9 Self-Test QuestionsThe Need for IPv6 1. the long bits of an IPv6 address.