cisco ccna 640-875 spngn1

cisco ccna 640-875 spngn1.5. Check the network connectivity between the two 2950 switches and Host3. Click on the label Lab Instructions and select 2950-1 from the drop-down list Devices; you can also click on the label NetMap, then double-click on the device icon 2950-1 o on switch 2950-1 Jt, ping Host-3: ping 192.168.3.10. Click on the label Lab Instructions, and select 2950-1 from the drop-down list Devices. and select 2950-2 from the drop-down list Devices; also click the label NetMap, then double-click the device icon 2950-2 o On switch 2950-2 _k, ping Host-3: ping 192.168.3.10 o Click the label Lab Instructions, and select from the drop-down list Devices Host-3; also click the tab NetMap, then double-click the device icon Host-3 o On Host-3, ping switch 2950-1: ping 192.168.1.2; on Host-3, ping switch 2950-2: ping 192.168.1.3.6. configure a static route to 10.0.0.0/8 on router 2600-2, which is the global address located behind router 2600-1. Remove the static route 192.168.1.0/24. Click the tab Lab Instructions, and select 2600-2 from the drop-down list Devices; you can also click the tab NetMap, and then double-click the device icon 2600-2o On router 2600-2, configure a static route: configure terminal and ip route10.0.0.0 255.0.0.0 192.168.2.1 Remove the original static route: no ip route 192.168.1.0 255.255.255.0 192.168.2.1o Exit configuration mode: endo 7. Check the routing table of the router 2600-2. Check the routing table: show ip route,confirm that the static route 10.0.0.0/8 is correctly configured.8. On router 2600.1, configure a static NAT translation entry for switch 2950-1 (10.0.0.2). Click the Lab Instructions tab, and select 2600-1 from the drop-down list Devices; you can also click the NetMap tab, and then double-click the device icon 2600-1o enter configuration mode: configure terminal. on router 2600.1, configure a static NAT translation entry for switch 2950-1 ip nat inside source static 192.168.1.2 10.0.0.2.9. configure fa0/0 as the NAT inside interface and configure sO as the NAT outside interface. Specify interface faO/O as the internal interface: interface fa0/0^ ip nat inside and exito Specify sO as the external interface: interfaces., ip nat outside and end.10. view the static translation entry: show ip nat translationso11. ping it at Host-3 using the global and local addresses of switch 2950-1 to test the translations. Click the label Lab Instructions and select Host-3 from the drop-down list Devices; you can also click the label NetMap, and then double-clickChapter 22 Address Translation 601Device icon Host-3o ping the global address of switch 2950-1 on Host-3: ping 10.0.0.2, which should succeed. On Host. 3, ping the local address of switch 2950-1: ping 192.168.1.2, this should fail (there is no route to this address)12. ping the local address of switch 2950-2 to check connectivity. On Host-3, ping the local address of switch 2950-2: ping 192.168.1.3, this should fail (there is no route to this address) o