cisco ccna 640-802 pdf

cisco ccna 640-802 pdf.Hands-On Exercise 22.1Configuring Static Address TranslationThe previous sections discussed how to configure address translation on an IOS router, and this exercise lets you configure a simple static NAT to help deepen your understanding of these elements. You will use the Boson NetSim simulator to complete this experiment. For a diagram of the network used by the Boson NetSim simulator, see the Preface to this book. In this exercise, you will first configure static routes on two routers (2600-1 and 2600.2) and check network connectivity; then, configure address translation. Start this simulator and click the tab Labs in the lower left corner of the window. then, click the tab McGraw-Hill in the upper left corner (tab Standard and Custom to the right) and double-click Exercise22-1,which will load the experimental configuration based on the exercises in Chapter 10 and Chapter 15.1. On Router 2600-2±, configure a static route to 192.168.1.0/24 via Router 2600-1. View the routing table. Click the tab Lab Instructions and select 2600-2 from the drop-down list Devices; you can also click the tab NetMap and then double-click the device icon 2600-2o configure a static route: configure terminak ip route 192.168.1.0 255.255.255.0192.168.2.1 and end. to view the static route: show ip route,confirm 192.168.1.0/24 as the static route(s)appears in the routing table.2. on router 2600-1, configure a static route to 192.168.3.0/24 via router 2600-2. View the routing table. Click the tab Lab Instructions and select 2600-1 from the drop-down list Devices; you can also click the tab NetMap and double-click the device icon 2600.1. to configure the static route: configure terminalip route 192.168.3.0 255.255.255.0192.168.2.2 and end. view static route: show ip route,confirm 192.168.3.0/24 appears in the routing table as static route(s).3. On Host-3, ping router 2600-1 interface fa0/0o Click the label Lab Instructions, and select Host-3 from the drop-down list Devices; you can also click the label NetMap, and then double-click the device icon Host-3o ping router 2600-1 interface serialO and faO /O: ping 192.168.2.1 and ping 192.168.1.1, these operations should be successful.4. on Host-3, pingHost-l0 pingHost-1: ping 192.168.1.10, this should be successful.