cisco ccna 200-301 library

cisco ccna 200-301 library.1. On router 2600-2 ±, configure a static route to 192.168.1.0/24 via router 2600-1. View the routing table. Click the label Lab Instructions and select 2600-2 from the drop-down list Devices; you can also click the label NetMap, and then double-click the device icon 2600-2o configure a static route: execute the command configure terminalip routel92.168.1.0 in order255.255.255.0 192.168.2.1 and endo to view the routing table: show ip route, confirm that 192.168.1.0/24 appears in the routing table as the static route(s).2. configure a static route to 192.168.3.0/24 via router 2600-2 on router 2600-1. View the routing table. Click the label Lab Instructions and select 2600-1 from the drop-down list Devices; you can also click the label NetMap, and then double-clickDevice icon 2600-1 o Configure a static route: execute the commands configure terminal, ip route 192.168.2.0255.255.255.0 192.168.2.2 and end. view the routing table: show ip route, confirm that 192.168.3.0/24 appears in the routing table as static route(s).3. on Host.3. check the connectivity to router 2600-1. Click the tab Lab Instructions,and select Host-3 from the drop-down list Devices;also click the tab NetMap,then double-click the device icon Host-3o ping router 2600-1's interface serial0 and faO/O: ping 192.168.2.1 and ping192.168.1.1, these operations should be successful.4. on Host-3, check the connectivity to Host-1. pingHost-1: ping 192.168.1.10, this should be successful.5. Check the network connectivity between switch 2950-k router 2600-2 and router 2600-1. Click on the label Lab Instructions and select 2950-1 from the drop-down list Devices; you can also click on the label NetMap, then double-click on the device icon 2950-1o in the switch 2950-1 ping router 2600-1: ping 192.168.1.lo click on the label Lab Instructions, and select 2600-2 from the drop-down list Devices; also click the label NetMap, then double-click the device icon 2600-2o on router 2600.2, ping router 2600-1: ping 192.168.1.1. click the label Lab Instructions, and select from the drop-down list Devices 2600-1; also click the tab NetMap, then double-click the device icon 2600-1o on router 2600.1, ping switch 2950-1: ping 192.168.1.20 on router 2600-1 ping router 2600-2: ping 192.168.2.2o 6. Configure a standard numbered ACL that lets traffic from switch 2950-1 pass through, but prohibits all other traffic from passing through. Click the tab Lab Instructions and select 2600-1 from the drop-down list Devices; you can also click the tab NetMap, then double-click the device icon 2600-lo on router 2600-1, create a standard ACL statement that lets traffic from 2950-1 pass through and writes the matches to the log: configure terminal and acce§s.list 1 permit host 192.168.1.2o Create another ACL statement that prohibits all other traffic from passing through and writes the match to the log: access-list 1 deny anyo Exit configuration mode: endo Check the ACL configuration: show access- lists7. on router