cisco ccna 1-4

cisco ccna 1-4.(192.168.30.1) is not correct and is disabled. Enter interface spider 0/0, correct the IP address, and enable it: execute the commands configure terminak interface fa0/0^ ip address 192.168.3.1 255.255.255.0, no shutdown, and endo in sequence to check the status of interface fhO/O: show interfacesfa0/0o showinterfacefa0/0o Try pingHost-3: ping 192.168.3.10, which should succeed.4. on router 2600.2, check the connectivity to router 2600-1. Try pinging router 2600-1's interface serial1/0: ping 192.168.2.1,This operation succeeds.Chapter 19 OSPF Routing 5195. Check the OSPF configuration of router 2600-2. Check the OSPF configuration of router 2600-2: show ip protocols, you should see the routing protocol OSPF and the networks 192.168.2.0 and 192.168.3.0 (0.0.0.0255.255.255.255.255). From these outputs, the OSPF configuration of the Router 2600-2 seems to be fine.6. Save the configuration of router 2600-2: copy running-config startup-configo7. Check connectivity to Host.1 on router 2600-2 and check the routing table. On router 2600-2±, check connectivity to Host-1: ping 192.168.1.10, which should fail, indicating a Layer 3 problem between router 2600-2 and Host-1. Check the routing table: show ip route, and notice that there are only two direct routes (192.168.2.0/24 and 192.168.3.0/24), and no OSPF routes.8. Go to router 2600-1, check its OSPF configuration, and fix the problem there. Click the tab Lab Instructions and select 2600.1 from the drop-down list Devices; you can also click the tab NetMap and double-click the device icon 2600-lo to view the routing protocol: show ip protocolso which networks does the router 2600-1 advertise? You see 192.168.100.0 and 192.168.2.0. obviously, the interface fa0/0 is not included, because no network is advertised 192.168.1.0o fix this configuration problem: execute the command configure terminaR router ospf 1 no network 192.168.100.0 in order 0.0.0.255 area 0^ network 192.168.1.0 0.0.0.255 area 0 and end. check for connectivity to Host-3: ping192.168.3.10, which should succeed. Save the configuration of this router: copy running-conflg startup-configo9. On router 2600.2, view the routing table and check connectivity to Host.1. Click the Lab Instructions tab and select 2600-2 from the drop-down list Devices; you can also click the NetMap tab and double-click the device icon 2600-2o view the routing table: show ip routeo notice that there are two directly connected routes (192.168.2.0/24 and 192.168.3.0/24 ), and one OSPF route ( 192.168.1.0/24). On router 2600-2, check connectivity to Host-1: ping 192.168.1.10, which should be successful.10. Check the connectivity from Host-1 to Host-3. Click on the label Lab Instructions and select Host-1 from the drop-down list Devices; you can also click on the label NetMap and double-click on the device icon Host-1o check connectivity to Host-3: ping 192.168.3.10, which should be successful.You should now be able to configure and troubleshoot OSPF more comfortably. Exam Requirements