cisco 300-165 dumps

cisco 300-165 dumps.15. fix the RIP configuration of router 2600-1. Fix this configuration problem: Execute the commands configure terminal router rip, no network192.168.11.0, network 192.168.1.0, and end. to view the routing protocol configuration: show ip protocols16. Use ping to check connectivity to Host-3. Check connectivity to Host-3: ping 192.168.3.10, which should be successful. Save the configuration of this router: copy running-config startup-configo17. Check the connectivity from Host-1 to Host-3. Click on the tab Lab Instructions and select Host-1 from the drop-down list Devices; you can also click on the tab NetMap and double-click on the device icon Host-lo to check connectivity to Host-3: ping 192.168.3.10, this should be successful.At this point, you should be able to configure IP RIP on the IOS router more comfortably.It is important to be able to troubleshoot connectivity, for example, by checking for errors in static routes, errors or omissions in network commands, connected routers running different routing protocols, incorrect addresses configured on interfaces (connected interfaces are on different subnets), no addresses configured for interfaces, interfaces disabled, connected routers running different RIP version of the connected routers is different, and the VLAN configuration on the switch is incorrect°.Authentication target 18.0418.4 Default Gateway RedundancyThe remainder of this chapter covers Layer 3 redundancy issues. When you think of Layer 3 redundancy, you usually think of having multiple paths to the same destination network and using dynamic routing protocols to find the best path or an alternative path, but this section discusses another type of Layer 3 redundancy: default gateway and server load balancing. These problems typically arise at the access and distribution layers (see Chapter 13). o I will begin with some of the default gateway redundancy problems and some of their solutions that have not worked very well. This section focuses on Cisco's Hot Standby Router Protocol (HSRP), as well as other solutions such as Virtual Router Redundancy Protocol (VRRP) and Gateway Load Balancing Protocol (GLBP) o18.4.1 Problems with traditional default gateway redundancy solutions