cisco 300-135 dumps pdf

cisco 300-135 dumps pdf.7. Check the IP configuration of Host-3. Click the LabInstructions tab, and select Host-3 from the drop-down list Devices; you can also click the NetMap tab, and then double-click the Device icon Host-3o execute the command ipconfig /all to check the IP configuration of Host-3; confirm that the IP addressing information is correct: the IP address is 192.168. The IP address is 192.168.3.10, the subnet mask is 255.255.255.0, and the default gateway address is 192.168.3.Io8. On Host-3, use ping to check connectivity to the default gateway ping the default gateway address: ping 192.168.1.1, this should fail, indicating a problem between Host.3 and router 2600-2. In this example, it is assumed that Layer 2 is operating normally, so the problem must be with router 2600-2 ±o9. Check the interface status and IP configuration of router 2600-2. Click on the LabInstructions tab and select 2600-2 from the drop-down list Devices; also click on the NetMap tab, then double-click on the device icon 2600-2o In router 2600-2 _h,pingHost-3: ping 192.168.3.10, which should fail. Check the corresponding interface on router 2600-2: show interface fa0/0; this interface is disabled, but its IP address is correct, enable the interface for 192.168.3.lo: execute the commands configure terminal, interface fa0/0no shutdown and endo in turn This The interface should enter the up state. Try the previous ping test again: ping 192.168.3.10, which should be successful. Check the status of the interface: show interfaces, notice that fa0/0 is disabled, but s0 is enabled (status up and knock). Enter the interface faO/O and enable it: execute the commands configure terminal, interface fa0/0no shutdown and endo in sequence to verify the status of interface faO/O: show interface fa0/0o10. On router 2600-2Ji,check the connectivity to router 2600-1. Try pingHost-3:ping 192.168.3.10, which should succeed. Try pinging router 2600-1's interface s0: ping 192.168.2.1, this also succeeds.11. Check the RIP configuration of router 2600-2. Check the RIP configuration: show ip protocols, you should see that the routing protocol is RIP and contains the networks 192.168.2.0 and 192.168.3.0. From this output, the RIP configuration of router 2600-2 looks correct. To save the configuration of this router.copy running-config startup-configo12. On router 2600-2±, check the connectivity to Host-1. Check connectivity to Host-1: ping 192.168.1.10, this should fail, indicating a layer 3 problem between router 2600-2 and Host.l.13. Check the routes in the routing table of router 2600-2. View the routing table: show ip route, and notice that there are only two directly connected routes (192.168.2.0/24 and 192.168.1.0/24),and no RIP routes.14. Go to router 2600-1 and view its RIP configuration. Click the LabInstructions tab and select 2600.1 from the drop-down list Devices;. You can also click the tab NetMap, and then double-click the device icon 2600-lo to view the routing protocol configuration: show ip protocols What networks does the router 2600-1 pass through? You will see 192.168.1.0 and 192.168.11.0. Obviously, interface s0 is not included because no network 192.168.2.0o is configured.