cisco 300-115 latest dumps

cisco 300-115 latest dumps.Video 18.07 A multimedia demonstration of executing the command debug ip rip on a router is included in the companion digital resource to this book.Hands-On Exercises 18.3Configuring RIP The previous sections discussed how to configure RIP on a router, and this exercise helps you deepen your understanding of RIP configuration and troubleshooting. You will use the BosonNetSim simulator to complete this experiment; see the Preface to this book for a diagram of the network used by the simulator. In this exercise, you will configure IP RIPvlo on two routers (2600.1 and 2600-2) After you start this simulator, click the tab Labs in the lower left corner of the window, click the tab McGraw-Hill in the upper left corner (tab Standard and Custom to the right), and then double-click Exercise 18-3, which will load the experimental configuration based on the exercises in Chapters 10 and 15. This will load the experimental configuration based on the exercises in Chapters 10 and 15. 1. verify that interfaces faO/O and s0 are enabled on router 2600-1, and enable them if they are not already enabled. Click the tab Lab Instructions and select 2600-1 from the drop-down list Devices; you can also click the tab NetMap, then double-click the device icon 2600-lo on router 2600-1 and use the command show interfaces to view the configuration. If interfaces faO/O and s0 are not enabled, go to those interfaces and enable them: execute the command configure terminaR interface type [slotjt/lportjt^ no shutdown and end in that order.2. view the IP addresses configured on router 2600-1. Use the command show ip interface brief to verify that the IP addresses configured in Chapter 15 are still present.Chapter 18 Basic Routing 4733. view the routing table for router 2600-1. Using the command show ip routeo you should see two directly connected networks: 192.168.1.0 connected by interface fhO/O and 192.168.2.0 connected by interface s0.4. On router 2600-2 -h, verify that interfaces faO/O and s0 are enabled, and if they are not, enable them. Click the tab LabInstructions and select 2600-2 from the drop-down list Devices; you can also click the tab NetMap, then double-click the device icon 2600-2O on router 2600-2 Ji, and use the command show interfaces to view the configuration. If the interfaces faO/O and s0 are not enabled, go to these interfaces and enable them: execute the commands configure terminak interface type port_#^ no shutdown and end in order. use the command show interfaces to check the configuration of the interface.5. check the IP address of the router 2600-2Ji configuration. Use the command show ip interface brief to verify that the IP addresses configured in Chapter 15 are still present.6. view the routing table for router 2600-2. Use the command show ip routeo You should see two directly connected networks: interface faO/O connected to 192.168.3.0 and interface s0 connected to 192.168.2.0.7. Check the connectivity between Host-1 and Router 2600-1. Click on the tab LabInstructions, and select Host-1 from the drop-down list Devices; also click on the tab NetMap, then double-click on the device icon Host-L on Host-1 and ping router 2600-1 (default gateway): ping 192.168.1.1, which should succeed.