cisco 300-115 dumps pdf

cisco 300-115 dumps pdf.network 192.168.1.0, metric 000:12:26: network 192.168.2.0, metric 1This command displays the routing updates sent and received on the router interface. In this example, the router receives a RIPvl update on interface Serial. from 192.168.1.2, which contains network 192.168.2.0, indicating that it can travel to that network via the notification router. Next, you see that the current router has generated a RIP update (local broadcast, destination 255.255.255.255) on interface Ethernet, which contains two networks: 192.168.1.0 and 192.168.2.0. Also, note the metric of these routes: 192.168.1.0 is directly connected to the current router, while 192.168.2.0 is directly connected to the current router. connected, while 192.168.2.0 is one hop apart. When the neighboring router to which interface EthemetO is connected receives this update, it will add 1 to the hop count for each of these routes-Exam Tip.Be sure to familiarize yourself with the output of the command debug ip rip used to troubleshoot RIP problems such as RIP version mismatches. Don't forget that debug commands can cause performance problems for the router and should be used only for troubleshooting and disabled when you are done.If the two routers are running different versions of RIP (vl and v2 respectively), the output will look something like the following when you run the aforementioned debug command on the router.00:12:25: RIP: sending vl update to 255.255.255.255via EthernetO 172.16.1.1) 00:12:26: network 192.168.1.0, metric 0 00:12:26: network 192.168.2.0, metric 100:12:32: RIP: ignored v2 packet from 192.168.2.1(illegal version)The debug command can only be executed in privileged EXEC mode. To disable a specific debug command, use the parameter no to undo it. To disable all debugging, use the command 11 ndebug all or no debug all.