cisco 200-301 volume 1

cisco 200-301 volume 1.18.1.5 Verifying and Troubleshooting Static RoutesTo verify the router's static and default route configuration, use the command show ip route.Codes: c -connected, S -static, I -IGRP, R -RIPZ M -mobile, B -BGP, D -EIGRP, EX -EIGRP external, 0 -OSPF, IA -OSPF inter area, N1 -OSPF NSSA external type 1, N2 -OSPF NSSA external type 2, El -OSPF external type 1, E2 -OSPF external type 2, E -EGP, i -IS-IS, LI -IS-IS level-1, L2 -IS-IS level-2, * -candidate default, U -per-user static route, o -ODRZ T -traffic engineered routeGateway of last resort is 0.0.0.0 to network 0.0.0.0172.16.0.0/24 is subnetted, 3 subnets172.16.1.0 is directly connected, EthernetO172.16.2.0 is directly connected, SerialO172.16.3.0 is directly connected, SerialO0.0.0.0/0 is directly connected, SeriallThis command displays the router's IP routing table, which may contain directly connected subnets, static routes, default routes, and routes dynamically learned by the routing protocol. The output of this command begins with a table of codes. These codes describe the various routes that may be contained in the routing table; in each route in the output, the first column is the route code. In this example, there are two directly connected routes (C) and two static routes (S). The first static route is considered a directly connected route because it was created with the outgoing interface specified. The second static route is the default route (the asterisk [*] indicates the gateway of last resort: the path the router will use if no other specific path is available).