cisco 200-301 topics

cisco 200-301 topics.18.01 Static Routing 18.04 Default Gateway Redundancy Two 18.02 Dynamic Routing Protocol Fundamentals Minute Sprint18.03 RIP Self-Test QuestionsChapter 14 introduced routing protocols, including the various types of routing protocols and their advantages and disadvantages. In Chapter 15, you R perform basic router setup through the command-line interface (CLI). This chapter describes the basic configuration of static routing and distance vectoring protocols, specifically the Routing Information Protocol for IP (RIP). The section that discusses RIP covers only its basics; its advanced configuration is beyond the scope of this book. However, after reading this chapter, you will be able to configure your router to route network traffic between router interfaces using static routes or R1P. The chapter concludes with various solutions that enable users to be able to use a redundant default gateway in the event of a default gateway failure.Authentication Objectives 18.0118.1 Static RoutingStatic routes are routes that are manually configured on the router and are typically used for small networks with few subnets and WAN links with limited bandwidth. For networks that contain hundreds of routes, using static routes is not scalable because you must configure each route and its redundant path on each router. This section describes static routing and some of the problems it has.Exam Essentials For networks that contain a large number of subnets, dynamic routing protocols are preferable to static routes because there are many target networks and configuring static routes is error-prone. Static routing is typically used for networks with few segments and networks with limited bandwidth (such as WAN links) o18.1.1 Configuring Static RoutesTo configure an IP static route, use one of the following two commands.Router(config)# ip route destination_network_# [subnet_raask\ IP_address_of_next_hop_neighbor [administrative_distance] [permanent]