ccna wireless 200-355 cost

ccna wireless 200-355 cost.switch(config)# interface type 0/port_# switch(config-if)# switchportmode access switch(config-if)# switchportaccess vlan VLAN_#The first thing you must do is specify the interface as an access interface using the command switchport mode access. The command switchport access vlan assigns the access interface to the specified VLAN.Exam Essentials If you use the command switchport access vlan to assign a switch port to a non-existent VLAN, IOS automatically creates that VLANOAfter you create the VLANs and assign the ports to them, you can use the various show commands to view and verify the configuration. The command show vlan displays a list of VLANs and the ports assigned to them: switch# showvlan1 default active Fa0/lz FaO/2, FaO/3, FaO/4 FaO/5, FaO/6, FaO/7, FaO/8 Fa0/9z FaO/lO, Fa0/llz FaO/12 FaO/13, Fa0/14z Fa0/15z FaO/16 FaO/17, Fa0/18z Fa0 /19z Fa0/20 FaO/21, Fa0/22, FaO/23, Fa0/24 Gi0/l, GiO/2)1002 fddi-default act/unsuj:In this example, all ports are assigned to VLANlo can specify the parameter brief in this command, which will not list the details of each VLAN at the end of the output. You can also use the command show interface switchport to view VLAN attribution information for a particular interface, as demonstrated earlier in this chapter in the section "Configuring Switch Trunking".Video 12.03 A multimedia demonstration of configuring VLANs on a switch is included in the digital resources that accompany this book.To create a VLAN, use the command vlan database or vlan; to assign an interface to a VLAN, use the commands switchport mode access and switchport access vlan. If an interface is configured as an access link, it cannot form a trunk connection. The command showvlan displays VLAN information: if an interface belongs to more than one VLAN, it may be a trunk interface.12.4.4 VLAN and Trunking Basic Troubleshooting