ccna v7 book pdf

ccna v7 book pdf.enabled for type vlan %SYS-5-CONFIG_I: A0 Configured from memory by console V0 3%SYS-5-RESTART: System restarted--Cisco IOS Software, C2 950 Software COM3LOOBRB 0x01Switch Ports Model* 1 26 WS-C2960-24TT-L 12.2(40)SE C2 9 6 0-LANBASEK9-M (C2950-LANBASE), Version 12.2 (40)SE, RELEASE SOFTWARE (fcl) Copyright. 1986-2006 by Cisco Systems, Inc. Systems, Inc. Compiled Fri 28-Jul-06 11:57 by yenanh %LINK-5-CHANGED: Interface Vlanl changed state to administratively down %LINK3-UPDOWN: FastEthernetO/1, changed state to up %LINK3-UPDOWN: FastEthernet0/2, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on interface FastEthernet0/1, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on interface FastEthernet 0/2 changed state to upBe sure to familiarize yourself with the switch's boot output, especially if you are using the factory-configured switch's boot output. When using the factory configurationWhen using the factory configuration, no IP address is assigned to VLAN1, so you cannot access the switch remotely.' iiAt the end of the output are status messages (they are prefixed with %) and version information for the loaded IOS. In this example, no configuration is defined (the factory configuration is used), so interface VLAN1 is administratively disabled (no IP address is assigned to it by default), and the physical and data link layer states of interfaces with active connections are both up (%LINK3-UPDOWN and %LINEPROTO-5-UPDOWN)11.2.2 System Configuration DialogIf no configuration is found, IOS will run the setup script one often referred to as the System Configuration Dialog. This script asks you a question to help it create a basic configuration on the switch. The setup script uses square brackets ([and]) when asking a question to indicate the default answer. If you do not answer, the script will use the default configuration inside the square brackets. In this script, you can configure the host name of the switch, set the privileged EXEC password, specify the Virtual Type Terminal (VTY) password, and assign IP addresses to VLAN interfaces for remote management of the switch.