ccna pdf notes with practical

ccna pdf notes with practical.Figure 21-4 Experimental topology for configuring classification and taggingR3(config)#ip http serverEnable HTTP service for testingR3(config)#servicefingerEnable finger service for testing R3(config)#line vty 0 4 R3(config-1 ine)#no loginConfigure Telnet password for testing1 Use ACL classification. I°R2(config)#access-list 100 permit icmp any any//match ICMP traffic R2(config)#access-list 110 permit tcp any any eq telnet match Telnet traffic R2(config)#access-list 120 permit tcp any any eq match HTTP traffic list 120 permit tcp any any eq www match HTTP traffic2 Use route-map marker c R2(config)#route-map ICMP permit 10 to define a route-map R2(config-route-map)#match ip address 100 to match ICMP packets R2(config-route-map)#setip precedence 2 to set the IP precedence marker to 2. route-map)#setip precedence 2 Set the IP precedence flag to 2R2(config)#interface Seria)0/0/0 R2(config-if)#ip policy route-map ICMP Apply route-map in the inbound direction of the interfaceThe command to define route map is route-map map-tag (permit | deny] [sequence~number\o Usually each route map statement contains match and set. match is used to match conditions, and the common matching conditions include IP address, interface, metric, tag, route type, and packet length, etc. set defines the set that is taken when the match condition is met.3 Mark with the Modular QoS Command-Line ( Modular QoSCommand-Line,MQC) tool. R2(config)#class-map match-all ICMP define class-map R2(config-cmap)#match access-group 100 define match type trafficR2(config-cmap)#exit R2(config)#class-map match-all TELNET R2(config-cmap)#match access-group 110 R2(config-cmap)#exit R2(config)#class- map match~all HTTP