ccna kit ebay

ccna kit ebay..323.Cisco Networking Lab CCNA Lab Guide (Release 2)[Technical Extensions].One of the design concepts of 0SPFv3 is the separation of topology and routing information: the basic LSAs that compute the topology (RouterLSA and NetworkLSA) no longer contain routing information. so the routing information carried in these two types of LSAs in the original OSPFv2 is described by a new LSA. which is the Intra Area Prefix LSAO The Intra Area Prefix LSA describes the routing information carried by the Router LSA and NetworkLSA, so the referenced RouterLSA or Network LSA needs to be identified in this LSA, which is described by the Referenced LS Type, Referenced Link State ID, and Referenced Advertising Router fields to jointly identify it.1 ReferencedLSType: a value of 0x2001 indicates that the LSA is related to RouterLSA; a value of 0x2002 indicates that the LSA is related to Network LSA.2 ReferencedLinkStateID: A value of 0 indicates that the referenced LSA is RouterLSA0; a value of 0x2002 indicates that the referenced LSA is the Network LSA.3 ReferencedAdvertisingRouter: The originating router of the referenced LSA. If the referenced LSA is a Router LSA, the value of this field is the Router ID of the router that generated the LSA; if the referenced LSA is a Network LSA, the value of this field is the RouterIDo the DR of the corresponding network(4) Check the related informationR2#show ipv6 ospf to view OSPFv3 process ID, router ID, router type, redistribution information, OSPF area information, and the number of times the SPF algorithm is executed, etc. Routing Process Hospfv3 ln with ID 222.2 OSPFv3 process ID and router ID Supports NSSA (compatible with RFC 3101)Supports NSSA (Not-So-Stubby Area) Supports Database Exchange Summary List Optimization (RFC 5243)Supports OSPF Database Exchange Summary List Optimization Event-log enabled, Maximum number ofevents: 1000,Mode: cyclic/// Event-log enabled, Maximum number ofevents: 1 000,Mode: cyclic Router is not originating router-LSAs with maximum metric Initial SPF schedule delay 5000 msecs Initial SPF schedule delay Minimum hold time between two consecutive SPFs 10000 msecs Hold time to prevent router from continuously running SPF algorithmMaxiraum wait time between two consecutive SPFs 10000 msecs// The router waits 10 seconds after running the SPF algorithm once before running it again (some output is omitted here)Number ofareas in this router is 1. 1 normal 0 stub 0 nssa// Number and type of areas Graceful restarthelper support enabled Enable GR helper function Reference bandwidth unit is 1000 mbps/// Calculate the metric reference bandwidth RFC1583 compatibility enabled