ccna cost 2019

ccna cost 2019.How to define an IPv6 ACL.The method of applying IPv6 ACLs under an interface.The experimental topology for configuring IPv6 ACLs is shown in Figure 9-4. This experiment configures RIPng throughout the network to ensure IPv6 connectivity.The following access control is achieved by configuring an IPv6 ACL on Router R2: 1 Deny the host in the network segment where PC1 is located to access Serverl's Web service. 2 Deny the host on the network segment where PC2 is located to ping Router R2. 3 Deny the host on the network segment where PC2 is located to access the Telnet service of Router R2.2016:11111::/64 2017:1212::/64Figure 9-4 Experimental Topology for Configuring 1 Pv6ACL(1) Configure router R1 Rl(config)#ipv6 unicast-routing Rl(config)#ipv6 router rip cisco R1 (config)#interface GigabitEthernetO/O R1 (config-if)#ipv6 address 2016:lllll::l/64 R1 (config-if)#ipv6 rip cisco enable Rl(config-if)#no shutdown R1 (config-if)#exit R1 (config)#interface GigabitEthernetO/1 Rl(config-if)#ipv6 address 2016:2222::l/64 R1 (config-if)#ipv6 rip cisco enable Rl(config-if)#no shutdown Rl(config-if)# exit R1(coiifig)#interfaceSerial0/0/0Rl(config-if)#ipv6address2017:1212::l/64R1(config-if)#ipv6 ripcisco enable Rl(config-if)#no shutdown Rl(config-iO#eXit.130.Cisco Networking Lab CCNA Lab Guide (Release 2)(2) Configuring the Router R2 R2(config)#ipv6 unicast-routing R2(config)#ipv6 router rip cisco R2(config)#interface GigabitEthernetO/O R2(config-if)#ipv6 address 2018:2222::2/64 R2(config-if)#ipv6 rip cisco enable R2(config-if)#no shutdown R2(config-if)#exit R2(config)#in terface Serial0/0/0 R2( config-if)#ipv6 address 2017:1212::2/64 R2(config-if)#ipv6 rip cisco enable R2(config-if)#no shutdown R2(config-if)#exit R2(config)#line vty 0 4R2(config-line)#privilege level 15 R2(config-line)#no login R2(config-line)#transportinput telnet R2(config)#ipv6 access-list szpt Create an IPv6 ACL, case-sensitive name