ccna collaboration test dump

ccna collaboration test dump.The experimental topology is shown in Figure 9-2. This experiment requires that only host PC1 is allowed to access the Telnet service of router R3 from 8:00 to 17:00 every day from Monday to Friday, and other traffic is not affected. Delete the extended IPv4 ACL defined in Experiment 2, and keep the RIPv2 configuration.Rl(conHg)#time-range TIME Define the time range 'IR1 (config-time-range)#periodic weekdays 8:00to 17:00. Technical Points IIn time range configuration mode, use the periodic command, the absolute command, or some combination of them to define a time range. The periodic specifies a recurring start and end time for the time range and accepts the following arguments: Monday, Tuesday, Wednesday, Thursday, Friday, Saturday, Sunday, Other possible values are daily (from Monday to Sunday), weekdays (from Monday to Friday), and weekend (including Saturday and Sunday). absolute specifies an absolute start and end time for the time range, with the following command.Router(config-time-range)#perio(iic days-of-the-week hh:mm to [days-of-the-week] hh:mmRouter(config-time-range)#absolute [start time date] [end time date]The following is an example of defining time-range with the absolute command: ". I.":-R1 (config)#time-range CCNA.124.Cisco Networking Lab CCNA Lab Guide (Release 2)R1(config-time-range)#absolutestart8:001may2018end12:001july2019 The above 2 commands mean to define a car time period "named CCNA,and set the start time of this time period to 8:00 pm on May 1, 2018 and the end time to 12:00 pm on July 1, 2019 July 1, 2019 at 12:00 noon.