ccna chapter 7 exam online

ccna chapter 7 exam online.Sl#deletevlan.datdelete the VLAN database fileSl#reloadFigure 8-5 Experimental topology for creating VLANs and dividing ports(2)Create VLAN SI(config)#vlan 2// Create VLAN Sl(config-vlan)#name VLAN2 Name VLAN, if not configured, the default name is VLAN0002S1 (config-vlan)#mtu 1500//ffi set the Maximum Transmission Unit (MTU), the default value is 1 500 bytes S1 (config-vlan)#state active Configure the VLAN state, after creating VLAN, the default state is active Sl(config-vlan)#no shutdown is enabled by default, but the shutdown command can shut down the VLAN Sl(config-vlan)#exit is executed before the created VLAN will be shut down.The created VLAN will take effect only after this command is executed Sl(config)#vlan 3 S1 (config-vlan)#name VLAN3 Sl(config-vlan)#exit(3) Divide the switch ports into VLANs S1 (config)#interface fastEthernetO/1 S1(config-if)^switchportmodeaccess// Configure the switch port mode to access Sl(config-if)# switchportaccess vlan 2// Divide the port into VLAN 2 Sl(config-if)#exit S1 (fig)#interface fastEthernetO/2 S l(config-if)#switchportmode access S l(config-if)# switchportaccess vlan 2 Sl(config-if)#exit Sl(config)#interface range fastEthernetO/3-4 Bulk configuration of ports to reduce configuration workload S l(config-if-range)#switchport mode access S1 (config-if-range)#switchportaccess vlan 3Multiple [end-of-technology point].1 When the VLAN created is a normal VLAN, the configured commands do not appear in the running-config file, and the VLAN information is stored in the vlan.dat database file. If you want to create an extended VLAN, you must first configure the VTP operating mode of the switch to transparent mode, and then all the commands for creating the VLAN (including normal VLAN and extended VLAN) will appear in the running-config file.