ccna certification study guide

ccna certification study guide.Rl(config)#iiiterface Serial0/0/0Rl(config-if)#ip summary-address rip 172.16.0.0 255.255.254.0 Configure RIPv2 manually for routing summary R1 (config-if)#exit Rl(config)#gigabitEthernetO/0 Rl(config-if)#ip summary-address rip 172.16.0.0 255.255.254.0 RI(config- if)#exit.80.Cisco Networking Lab CCNA Lab Guide (Release 2)Female [End of Technical Extension] If the G0/1 and G0/2 interfaces of router R1 are on networks 192.168.0.0/24 and 192.168.1.0/24, respectively, can you manually summarize these 2 routes under the interfaces? When the manual summary command is configured, the prompt message is as follows: Rl(config-if)#ip summary-address rip 192.168.0.0 255.255.254.0 Summary mask must begreater or equal to major net The prompt message displayed indicates that the summary (2) Configuring Router R2R2(config)#key chain ccna Configure the key chain R2(config-keychain)#key 1 .TSE set Key ID R2(config-keychain-key)#key-string cisco Configure the key for Key ID R2(config-keychain-key)#key-string cisco Configure the key for Key ID R2(config-keychain-key)#key 1 . keychain-key)#exitR2(config-keychain)#exit R2(config)#router rip R2(config-router)#version 2 R2(config-router)#no auto-summary R2(config-router)#network 172.16.0.0 R2(config-router)#exit R2(config)#interface Serial0/0/l R2(config-if)#ip rip triggered configuration triggered updateTriggered update configuration is not supported under Ethernet interfaces. Two-plus-han triggered updates require negotiation, and both ends of the same link need to be configured.R2(config-if)#ip rip authentication mode MD5//Enables MD5 authentication mode, the default authentication mode is plaintext( text) R2(config-if)#ip rip authentication key-chain ccna//Invokes the key chain on the interface R2( config-if)#exit(3) Configure router R3