200-301 labs

200-301 labs.Table 3-6 4 Reasons a Switch Cannot Transmit a VLAN Communication on a Specific TrunkTable 3-7 Combining the switchport mode Command and Link Trunking Inference Results3.3.2 Complete the tables and lists from memory Print Appendix D (found on the accompanying CD-ROM) or the relevant parts of the chapter and complete the tables and lists from memory. Appendix E, which is also on the CD-ROM, contains completed tables and lists that can be used to check your answers.Answers to Troubleshooting Example 1 If Troubleshooting Example 1 is used as an exercise, the questions that should be identified in the summary exercise are as follows.. Figure 3-5 shows that port Fa0/10 of SW2 is connected to router R1 while port F0/9 of SW2 is shown on the CDP. This example can be used to resolve a network failure by updating the network diagram to list FaO/9. Port F0/12 of SW1 (which may be connected to PC2 as seen in Figure 3-5) is in the unconnected state. However, it may not be possible to identify a specific reason why it is in this unconnected state in this example. (In fact, the cable is not tapped and is only tapped when preparing Example 2.) SW3's FaO/13 port may be in a duplex mismatch state. It lists the rate/duplex setting as a-100/a-half, which will only happen if the other device (PC13) has autonegotiation disabled and has set itself to 100/fUll. Manually configuring the switch to use full duplex solves this problem.Port security for port SW1F0/11 filters data from the only device connected to the port (PC1, 0200.1111.1111) because the MAC address 0200.3333.3333 was incorrectly configured. The security configuration of this port is to be updated to the correct MAC address 0200.1111.11110. port F0/9 on SW2 is connected to R1 and is assigned to VLAN 1, while port F0/10 (which is connected to R1 in Figure 3-5) is assigned to (the correct) VLAN 3. the cable should be removed or F0/9 should be placed in VLAN 3. This book was written by reconfiguring port F0/9 on SW2 with the switchport access vlan 3 command.Pre-test ReviewFollow Table Pl-l to follow the progress of the review. Record the details of each task. Table P1-1 Review Scenarios for Part 1