ccna bootcamp cost

ccna bootcamp cost.High Availabilityand ScalabilityWizard.UnifiedCommunicationWizard.PacketCapture Wizard.9.2.4.2 Startup WizardThe Startup Wizard guides the administrator through the initial configuration of the ASA and helps define basic settings. The Startup Wizard can be activated by selecting Wizards > Startup Wizard or Configuration > Device Setup > Startup Wizard. After the Startup Wizard page appears, click the Launch StartupWizard button.The actual number of steps in the wizard will vary depending on the ASA model and the modules installed. However, most ASA models can beHowever, most ASA models can be configured to follow a 9-step process. After activating the Startup Wizard, follow these steps to configure it. Step 1 The Start Point window (also called the Welcome window) provides the ModifyanExistingConfiguration option and ResettheConfiguration to Factory Defaults o select one of these and click Next to continue. Step 2 In the Basic Configuration window, complete the basic ASA administration configuration, including the configuration of the hostname, domain name, and privileged enforcement password. As an option, this step may also allow the administrator to deploy ASAO for remote workers Complete these options and click Next to continue.Step 3 In the Interface Selection window, create a VLAN switching interface. This step is specific to the ASA5505 model. Complete this option and click Next to continue. Step 4 In the Switch Port Assignment window, map the Layer 2 physical switch ports to the logical VLANs that were named in the previous step o By default, all switch ports are assigned to VLAN1 (internal). Click Next to continue. Step 5 In the Interface 1P Address Configuration window, identify the internal and external IP addresses for the defined VLANs. Note that these addresses can also be created using DHCP or PPPoE. Complete this option and click Next to continue. Step 6 The DHCP window allows the administrator to enable DHCP services for internal hosts. All DHCP related options are defined in this window.Complete this option and click Next to continue. Step 7 The Address Translation (NAT/PAT) window allows the administrator to enable PAT or NAT. complete this option and click Next to continue. Step 8 On the Management Access Port, specify which host(s) will be allowed to access the ASA using HTTPS/ASDM.